Samurai efi setup, 4.62 3rd, Transmission, transfer case

[Livetodrive]

I have these extra parts left over and i need to make room in the garage

1) 4.62 3rd member from the front end of sidekick, great shape. $100

2) Complete EFI setup from a 1990 Samurai; includes intake manifold with throttlebody and attached sensors/vaccum lines, map sensor, ecu, efi dizzy, gas tank with fuel pump, and ENTIRE wiring from the vehicle. $275

3) Transmission from 1990 samurai: works perfect, shifts great, i drove it for over a year and can testify for the trans. $150

4) Transfer case from 1990 samurai; bearings are shot, rebuildable with a new bearing kit. $50

5) i also have an intermediate drive shaft, and either a front or rear shaft left, both large flange, make offer

I am located a few minutes north of Biloxi, ms. I can ship most of this stuff on your dime. I can also try to help out by driving to meet in the middle etc for my gas covered. You can either pm me on here or call my cell at two-two-8---8-six-one------eight 5 three 5
-Chris-